Cablely Cowl
by Mar Heck ©2019
This is a really easy cowl/neck warmer that you can
knit up in really short order. Makes a
nice gift and you can make several for yourself too! I knit it on a midgauge machine, but you
could make it on other machines adjusting the gauge so that you end up with a
cowl that is 6”+ x 24”+. Use any yarn that works with your machine. Variegated is nice. The cables make automatic buttonholes! Directions
are given for the midgauge or bulky. To
knit on other gauge machines, get your gauge, then take a tape measure or piece
of yarn and wind around your neck to see what length you want.
Machine: Midgauge – I used Brother KX 350
Yarn: Lion Brand Wool, worsted weight, run together
with mill end variegated thread (poly and cotton slubs) – optional, or use any
worsted weight yarn.
Other: 2 one inch buttons
Gauge: 4 st x 5 rows = 1”
(not too critical because you can block and also adjust the button placement)
Suggested Finished sizes: After
blocking, 6” height x 22” length, 8” x 24”, 8” x 28”
Directions: Cast on with waste yarn over needles R 1-25 and knit a
few rows T 10. 5
E wrap loosely over all needles with main
yarn. Knit one row. Transfer stitches as
in diagram.
In other words, put
needles 3, 8, 13, 18, 23 out of work when you cast on over right 1-25. If you are making a wider scarf, continue in
the same pattern leaving two plain stitches at the sides.
Knit 10 rows. (I did 10 rows because it is faster and also
easier to keep track of on the row counter.)
Cable: With two 2-prong tools, *make
a 2 x 2 cable on stitches 4,5,6,7—9,10,11,12—14,15,16,17—19,20,21,22 (counting
the needles out of work), Knit 10 rows.*
Repeat from * to * 8 or more times, knit 10 rows plain, one loose row and chain
cast off pulling next stitch through the previous stitch with your latch hook. OR, use the bind off of your choice. Remove waste yarn. Note that the sides of the cables form holes
that are decorative and also act as automatic buttonholes. And, with serious blocking, you can make scallops.
Finishing: Block the rectangle aggressively, pinning out
the space between cables on both edges to make curvy lines. Steam press hard if using wool, steam above
the fabric if using acrylic, and leave pinned until it dries. Remove waste yarn and sew in/hide yarn
ends. Sew on buttons two inches in from
the end. (Or, adjust size for recipient.) OPTIONAL- Bend over top corner and tack down
invisibly with sewing thread. I left the
bottom more open rather than sewing on another button to better conform to a person’s
neck, but you can add a 3rd button.
The red cowl pictured is more fitted to the neck. You may want a looser one.